MT Course Code: 21-71947
GWO BTT Installation Mechanical & Electrical Combined
Accreditation bodyGWO
Accreditation bodyGWO
Introduction to GWO BTT Installation Mechanical & Electrical Combined
The GWO BTT Installation Mechanical & Electrical Combined module prepares you for safe and effective work on wind turbine installations. You can take this course fully face-to-face or as a blended programme, starting theory online before practical sessions at the training centre.You'll need to complete the e-learning within 28 days before your practical training and upload valid ID and your WINDA number for identification.
Essential information
01
Prerequisites
Before attending the BTT Installation module, you must have completed both the BTT Mechanical and BTT Bolt Tightening modules.
02
Who is it for?
This training suits those new to hydraulic, mechanical, electrical, or installation systems, and those unfamiliar with energy-powered bolt tightening. It also helps upskill candidates with some knowledge but no wind turbine-specific experience. New technicians entering wind turbine installation Candidates seeking to upskill in installation practices Personnel involved in mechanical assembly and completion
03
Assessment
You’ll be assessed through direct observation and oral questions during practical tasks to check your understanding. There’s also a written phase test covering the learning objectives to confirm your knowledge.
04
Certification
After successfully completing the course, you’ll receive a GWO BTT Installation Mechanical & Electrical Combined certificate. This qualification is valid indefinitely and recognised worldwide within the wind energy sector. It’s issued under the Global Wind Organisation standards.
Course content
Introduction to Installation
Overview of module scope, safety, and emergency procedures.
General Onsite Procedures
Standard practices for working in various installation environments.
Handling and Storing
Techniques for managing materials and components safely.
Lifting Operations
Training in safe and efficient lifting techniques and equipment usage.
Main Component Preparation and Assembly
Step-by-step guidance on pre-assembly, assembly, and mechanical completion.
Principles of Hydraulic and Electrical Completion
Understanding and applying key principles for operational readiness.
Key Learning Objectives
LO1 - Explain the module scope, safety requirements, and emergency procedures.
LO2 - Demonstrate standard onsite procedures for various installation environments.
LO3 - Apply safe techniques for handling and storing materials and components.
LO4 - Perform main component preparation, assembly, and mechanical completion.
LO5 - Identify and apply principles of hydraulic and electrical completion.
FAQ
Still have questions?
Suggested Courses
GWO BTT Installation Mechanical & Electrical Combined
Location:
Esbjerg (Denmark) | Humber (United Kingdom) | Natal (Brazil) | Newcastle (United Kingdom) | Saudi Electric Services Polytechnic (Saudi Arabia)
Esbjerg (Denmark) | Humber (United Kingdom) | Natal (Brazil) | Newcastle (United Kingdom) | Saudi Electric Services Polytechnic (Saudi Arabia)
Language:
DK | EN | PO | SP
DK | EN | PO | SP
GWO BTT Installation Mechanical & Electrical Combined
Location: Esbjerg (Denmark) | Humber (United Kingdom) | Natal (Brazil) | Newcastle (United Kingdom) | Saudi Electric Services Polytechnic (Saudi Arabia)
Language: DK | EN | PO | SP